If you’re using bare wire, you need to make sure that it’s held down tightly by the binding post screws, without too much excess wire visible.Īssuming everything is correct and connected properly, the next best guess is that the problem is with a setting in your receiver’s software. ‘Connected properly’ means the power cable is fully inserted and the speaker wires have been properly pushed in (if you’re using banana plugs). Don’t laugh – it’s more common than you think. The next thing you need to do is check that your AV receiver is connected properly. You can’t read the rest of this guide if you’re dead from an electric shock. Step one: unplug your receiver from the power source. For that to happen, every single speaker in your setup would have to go on the fritz all at once, which isn’t going to happen unless there is a catastrophic power surge at the exact moment you sat down. The good news is that it’s extremely unlikely you’ve suffered a complete system failure. But you can’t, because there’s no sound coming out of your speakers. You’ve taken everything out of the box, connected it, spent hours fiddling with inputs and stripping speaker wire, and you’re finally ready to crash on the couch with a bowl of popcorn and watch Netflix in glorious 5.1.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |